MasterEmaco T 1060 Cement-Based, Concrete Repair Mortar packaged in a 50 pound bag
Watch how to apply MasterEmaco T 1060 cement-based, concrete repair mortar (Video Transcript). Then learn more about the materials, tools and accessories required to do the job safely and efficiently.
MasterEmaco T 1060 Repair Mortar Application Video Transcript
Concrete must be structurally sound and fully cured. Surface should be prepared following current ICRI Guideline No. 310.2R surface preparation guide.
Surface to be repaired must be saturated-surface dry (SSD) with no standing water
Precondition material to 70 degrees Fahrenheit (21 degrees Celsius)
Add 5.5 pints (2.6 L) of potable water into a clean mixing container
Gradually sift in powder, 1/3 of the bag at a time, while mixing continuously at a slow speed
Mix for a minimum of 3 minutes to ensure a uniform, lump-free consistency
Using a stiff bristle broom, scrub a small quantity of mixed material into the SSD substrate
Work material firmly into the bottom and sides of patch. Avoid feather edging.
Placement time is approximately 5-10 minutes
Finish the completed repair as required
Cure with an approved curing compound that complies with ASTM C309 or ASTM C1315
Refer to the MasterEmaco T 1060 technical data guide for more information.
Repair Mortar Application Materials, Tools and Accessories